كيفية استخدام تابع ضمن ملف dll
#4
شكرا اخي ناجي
تم تنفيذ التابع بنجاح واطلب تفسيرك إذا كان بالامكان للتابعين التاليين ضمن نفس المكتبة وشكرا:
التابع الأول SNAPI_SnapShot:
PHP كود :
SNAPI_SnapShot Host to Scanner Command
If the scanner supports imaging, this sends a command to the scanner to enter Image Capture Mode. The
scanner remains in Image Capture Mode until the trigger is pulled 
(physically or with a call to
SNAPI_PullTrigger
) and an image is captured, or until the timeout for a trigger pull expires. The scanner then
returns to Decode Mode
.
If 
the trigger is pulled, the image data is sent to the DLL. WM_XFERSTATUS is sent to the host application with
information about the size of the image
.
When the first transfer status message is received, the host application should provide a destination buffer for
the image by calling SNAPI_SetImageBuffer. After the entire image is transferred from the scanner to the DLL,
the application receives a Windows message indicating that the image data was stored.
Syntax
SNAPIDLL_API int __stdcall SNAPI_SnapShot
(
HANDLE DeviceHandle);
Parameters
DeviceHandle
Handle of the device used in the call to SNAPI_Connect
. 

التابع الآخر :
PHP كود :
SNAPI_GetSerialNumber Data Request Command
This command returns the serial number of the connected scanner
. No command is sent to scanner.
Syntax
SNAPIDLL_API int __stdcall SNAPI_GetSerialNumber
(
HANDLE DeviceHandle,
unsigned char *SerialNo);
Parameters
DeviceHandle
Handle of the device used in the call to SNAPI_Connect
.
SerialNo
Pointer to a buffer to receive serial number of connected scanner
. 

في التابع الثاني كيفية معرفة ماهي قيمه المتغير
الرد


الردود في هذا الموضوع
كيفية استخدام تابع ضمن ملف dll - بواسطة hytham100sy - 04-09-2013, 10:30 PM

التنقل السريع :


يقوم بقرائة الموضوع: بالاضافة الى ( 1 ) ضيف كريم